Driveway and Parking Lot Sealer & Crack Filler

Product No. 555 Driveway and Parking Lot Sealer

Product No. 555 is a quality no-stir gel that renews blacktop surfaces and provides lasting protection. Latex enhanced for longer life.

$29.99/ 5 Gal.

Download PDF

pdf

Product No. 210d Driveway and Parking Lot Crack Filler

Product No. 210d is a thick filler for cracks and dents in driveway and parking lot blacktop surfaces.

$54.99/ 5 Gal. and $15.99/ 1 Gal.

Product 210D Specification Sheet

Description: Elastomeric Emulsion Driveway Crack Filler is an undercoating used as a crack filler for Product #555 Driveway and Parking lot sealer. This product, which is black in color, promotes proper adhesion to the substrate. This coating forms a thick, crack resistant shield that resists peeling and cracking. This filler is used for filling any cracks that may need it prior to applying the Driveway and Parking lot sealer.
Uses: Elastomeric Emulsion is especially recommended as a driveway crack filler prior to sealing.
Surface Preparation: Surfaces to be coated must be cleaned thoroughly of all scales, loose mortar, rust, dirt, oil, grease and all foreign matter using a wire brush, sand blast or other materials in keeping with good practice. Dusty or porous masonry should be primed using the product at a 10% dilution rate with water and allowed to dry thoroughly before coating with emulsion. Likewise, old roofs and all metal should be primed prior to coating.
Application: Material should be stirred in the container and applied by soft bristle brush, long nap roller or suitable spray equipment. Adequate protection for most surfaces is obtained by the use of not less than 2-6 gallons of Elastomeric Emulsion Roof Coating per 100 sq. ft. of surface area. For spraying, use a heavy duty airless spray unit (tip size approximately 60 thousandths of an inch), follow manufacturer’s recommendations for spraying Elastomeric Emulsions. All Elastomeric Emulsion Coating’s “set” by dehydration. The rate of drying is dependent upon the thickness of application, temperature, humidity, and rate of air movement. Product should not be applied when raining or when rain or frost forecast within 24 hours. Apply only when temperature is 45 degrees F and rising.
Clean-Up: All equipment can be cleaned immediately after use with soap and water. Dried material can be cleaned with mineral spirits or biodegradable terpene solvent.
Typical Physical Properties: Total Solids: 45-50%; WT/Gal.: 9lbs.; Firm Flexibility: Good; Consistency: Brush, Spray or Squeegee; Coverage: Approx. 2-6gal/100 sq. ft. per coat; Weatherability: Excellent; Drying Time: 1/16″ wet film (normal conditions) Touch: 5 hours, Firm: 12 hours; Flammability, Wet: Non-Flammable, Dry: After exposure to Bunsen flame for 3 minutes the film will show self extinguishing properties in less than one minute. Film will char in place. VOC: <50 grams/liter;
Coating should be applied under normal environment conditions without thinning.)
Shipping Weights: 5 gal. Pail, 48 lbs. (each)

Download PDF

pdf