Product 300 Specification Sheet

Description: Bright Coat Aluminum Paint is a quality, reflective, non-fibered coating with a myriad of aluminum flakes suspended in a tough and flexible vehicle of selected asphalt and solvent. Upon application the aluminum flakes leaf to the surface to form a reflective metal shield that insulates against winter moisture.
Directions: Surface Preparation: All surfaces should be dry, clean, smooth, and in good repair. Surface temperatures should be 50° F or warmer, not to exceed 104° F. Priming is not normally required and should be used only if and as recommended by the manufacturer. In cold weather, store product in a heated room (65° F to 80° F) at least 24 hours prior to coating. When the coating is applied to an asphalt coated surface, it is suggested that the surface have at least the equivalent of one complete summer of weathering. Applications to new asphalt coated surfaces may result in bleed-through and alligatoring. DO NOT THIN. STIR CONTENTS WELL BEFORE AND DURING USE AS REQUIRED. The aluminum pigment and filler settle out; thorough stirring is necessary to re-disperse these components prior to use. The container should be tightly sealed to prevent solvent evaporation and to keep out moisture. Water may react with aluminum pigment to produce hydrogen gas, and explosion hazard.
Application: Apply coating evenly by brush on asphalt, metal or composition roofs. Spread in both horizontal and vertical directions, overlapping ends of strokes. Avoid excessive build up or puddling. When brushing avoid scraping into existing roof surface. All finish strokes should be made in the same direction. Due to irregular and different types of surfaces, recommended coverage rates are approx.: Mineral Surface Roofing, 1 gal. per 100 sq. ft.; Smooth Surface and Metal Roofing, 1/2 gal. per 100 sq. ft. Avoid foot traffic until firmly set. DO NOT APPLY IF RAIN IS IMMINENT.
Note: It is not recommended for use on wood, severely weathered asphalt shingles, coal tar surfaces, or roofs with slopes less than 1% (or 1/8" per ft.) because standing water dulls the aluminum and may cause adhesion failure between the coating and substrate. Application to steep slopes may result in some running in the coating.
Regulatory/Environmental Characteristics: Volatile Organic Compound: 500 g/l max. (4.2 lbs./gal.), HMIS Rating: H-2, F-2, R-3, PP-X, RCRA Hazardous Substances: Yes, D001, RQ value 100lbs., SARA Title III Listing: Sec. 302 Extremely Hazardous Substances: no, CERCLA Hazardous Substances: no, Sec. 313 Toxic Chemicals: no, California product meets Los Angeles County APCD rule 66 (Rule #102)
Typical Physical Characteristics: Weight Per Gallon, lbs.: 8.6-8.8; Residue by Evaporation, %:55min.; Combustible Solvents: Mineral Spirits; Consistency: Brush Spray; Cure Time (At Recommended Coverages): 4-8 hours to set 24-48 hours to full cure, depending upon weather conditions; Application Temperatures: 50° F-120° F; Flammability (Flash Point, °F Solvent): 105° F; Clean Up Tools: Mineral Spirits.
Shipping Weight: 1 Gallon (3.8L): 9 lbs.; (6) 1 Gallon Containers/Case: 55lbs., 5 Gallons (18.9L): 45 lbs., 55 Drums (208.2L): 520 lbs., Note: All approximate weights include container.

Roofing Products | Stucco & Wall Coatings | Complete Roofing Systems
Applying Stucco & Wall Coatings | Re-coating Your Roof | Home

E-mail: info@rubberized.com

Copyright © 2004 - Tucson Rubberized Coatings